• Máy lạnh
  • Dàn lạnh giấu trần nối ống gió VRV Mitsubishi Heavy Inverter 10.0 HP (10 Ngựa) FDU280KXZE1
Inverter

Dàn lạnh giấu trần nối ống gió VRV Mitsubishi Heavy Inverter 10.0 HP (10 Ngựa) FDU280KXZE1

  • Lh: 0902 820 616
  • Hỗ trợ trả góp lãi suất thấp, quẹt thẻ tận nơi.
  • Mở cửa từ 08 - 18h cả T7, CN. 
  • Bảo hành chính hãng, hệ thống trạm BH toàn quốc tận nhà quý khách:
  • Thùng máy lạnh nguyên đai - nguyên kiện theo tiêu chuẩn NSX
  • Cam kết sản phẩm chính hãng  mới 100%. Bồi thường 200% nếu phát hiện máy không chính hãng.
  • Miễn phí vận chuyển nội thành TP. HCM.
    Hỗ trợ giao hàng lắp đặt nhanh - ngoài giờ theo yêu cầu.
    GIAO HÀNG TỈNH NHANH 24H.
  • Kỹ thuật đào tạo từ hãng, chỉ sử dụng ống đồng dày >0.71mm, nhập chính hãng Malaysia, dây điện Cadivi,...
  • Hỗ trợ thiết kế bản vẽ kỹ thuật AutoCAD cho hệ thống lạnh KH.
  • UY TÍN TRÊN 20 NĂM TRONG NGHÀNH ĐIỆN LẠNH.
  • BẢNG GIÁ MÁY LẠNH 

 

Diện tích và khối không khí tính theo phòng trong điều kiện lý tưởng, phòng kín, tường bê tông, cách nhiệt chuẩn.
Mô tả sản phẩm

External Static Pressure(E.S.P) control

You can set External Static Pressure (E.S.P.) by method of manual setting on remote control. Indoor unit will control fan-speed to keep rated air flow volume at each fan speed setting. You can set required E.S.P. by wired remote control that calculated with the set air flow rate and pressure loss of the duct connected.

Quiet operation:45dB(A)

Thanks to use of DC fan motor, fan steps increase from two to four and quiet operation is achieved. (Sound pressure level 45dB(A) in the Lo mode).

Improvement of the serviceability

Fan unit (impeller and motor) can be pulled out from the right side of the unit. Maintenance can be available from the right side or the bottom side. (Common for FDUM22~160KXE6F & FDU45~160KXE6F)

Remote control (option)

Specifications

1. The data are measured under the following conditions(ISO-T1). Cooling: Indoor temp. of 27ºCDB, 19ºCWB, and outdoor temp. of 35ºCDB. Heating: Indoor temp. of 20ºCDB, and outdoor temp. of 7ºCDB, 6ºCWB. External static pressure of indoor unit is 72Pa.

2. Sound pressure level indicates the value in an anechoic chamber. During operation these values are somewhat higher due to ambient conditions.

*Powerful-Hi can be selected. Sound pressure level: FDU224/280 52dB(A). Air flow: FDU224/280 80m3/min.